Automatic water supply intelligent water pump controller
The automatic pump controller is simple and efficient. When the
pump is started to pump water, it is often forgotten to shut it
down, resulting in waste of electricity and water. The installation
of the fully automatic pump is simple and efficient to solve the
start and stop of the pump. When the pool is filled with high water
level, the pump water supply is stopped by the sensor signal. When
the pool is at low water level, the sensor signal starts the pump
to pump water.
The automatic water pump controller adopts digital core with
overload, no load and ultra low voltage protection. The upper and
lower levels and pressure are automatically controlled in one.
Can be connected to float control, pressure gauge control and probe
Description of the display and operation area
Description of wiring connection and parameters setting area
Wiring connection for both lower pool and upper pool water level
Under this mode, the no-load protection value must be set as 0.00A.
When the upper pool water level reaches to middle level, the
controller starts the pump, and it stops
at the high level of upper pool.
When the lower poor water level reaches to high level, the pump
controller will start the pump, and it
stops at middle level of lower pool.
Both of the low level probes are used to make a close-loop circuit
|Inverter Model||Suitable motor||Pump quantity||Breaker|
|Single phase 220V|
|Three phase 220V|
|Three phase 380V|